Store ZINGAi ZINGASOLVneobhodimo in fire-proof place in tightly closed containers in a well ventilated area away from heat, sparks and open flame. APPLICATION ZINGA the protected surface Application ZINGAna protected surface can be done with a brush, dipping, rolling, air and airless spraying. The advantage of covering the lack of bruises and blisters with any inclination of the workpiece. As already said composition should stir every 20 minutes. In the aerial application of the distance to the surface should be 15-30 cm depending on the shape of a torch. Ambient temperature during application can be from -20 to +50 C, the difference between surface temperature and dew point – more than 3 C, maximum relative humidity – 98%.

Under certain circumstances Zingamozhet applied and under more severe conditions. If used as ZINGA self-cover (without drawing on top of other protections), the recommended total dry film thickness should be 80-150 microns. In this ZINGA applied two or three layers of 40-60 microns each. Welds must be pre- to handle a brush. The tension at the corners and edges of the surfaces coated with Zinga, requires application of at least two or three additional layers of previously applied in cases where the surface is exposed to strong corrosion (as mentioned in the section on surface preparation). After the first coat by brush or roller to apply a second coat ZINGArekomenduetsya 1 hour at a temperature of 18-25 C and 15 minutes at 50 – 60 C.

When applied ZINGAraspyleniemvtoroy layer can be applied after the acquisition of the first layer of a uniform light gray color (15-20 minutes). When boleepozdnemnanesenii second (third) layer should be tested for the absence of surface contamination. If the surface layer of the previous hit the dirt, you need to rinse it with water or steam under high pressure (depending on the nature of contamination).