Production of blister packaging presents no special difficulties, and takes a little time. Due to this blisters are very popular among producers of various commodities. Production of blister Packaging and economically beneficial to businesses, in addition, blisters made any parties: from a single product to large orders. Production of blister package consists of several major stages. Firstly, designed and manufactured tooling (form), which will run the whole lot of blisters. Secondly, the production of blister packs include thermoforming a polymer film – the actual manufacturing of blisters. Third, holds a cardboard substrate, if it is necessary for the production of blister packs. Finally, the production of blister packs is completed assembly of the blister and placing the substrate and the packaging of the product. Thus, the production of blister begins with tooling. Typically, the blisters are shaped product to be placed in them. Accordingly, the apparatus for manufacturing blister packaging should give polymer film required shape. Once the shape is made, it set in a vacuum-molding machine. Production of blister packs is as follows: in the apparatus of stretched film warmed up to the soft plastic state. Bottom to the film raised form and on the same side vented. Between form for the production of blister packs and the film, a region of low pressure or vacuum, because of which the polymer adheres to the form (under air pressure located over the film). In fact, the production of blister packs is forming, where the role played by the punch airbag. Blisters are removed from vacuum-molding machine, cut (cut down) if necessary, and go further. Production of blister in the next step – the connection blisters and the substrate. Typically, the substrate using a sealed cardboard: it is applied to the product name, advertising information, instructions and other information. This product is placed in a ready-blister, and then connects to a prearranged substrate – the production of blister packs is completed.